- HHO Browns Gas Generator kit hydrogen engine carbon cleaner for combustion chamber
Categories Engine Carbon Cleaning Machine Album View larger image Brand Zeayeto Model HHO-1500 Gas production 2000 L/H±10% Working pressure ≤0.020bar Ambient temperature range 5℃～50℃ Altitude range-sea level to 2400m Frequency 50/60HZ Power ＜6 KW FOB port Shenzhen Terms of Payment L/C, D/A, D/P, Western Union Download DOC Update Time 2020-02-27Detail Information
HHO Browns Gas Generator kit hydrogen engine carbon cleaner for combustion chamber
1. Using pure water and electrolytes to produce Hydrogen and Oxygen.
2. The gas enter the engine system through pipelines.
3. Cleaning carbon only needs 20 minutes.
4. Through removing the engine carbon deposit to decrease the fuel consumption.
5. Finally the carbon becomes CO2 and H2O draining the exhaust pipe.
6. No need to dismantle engines parts
7. No harm to engine, human and environment
8. Much cost saving than the other machine.
AC Voltage Requirement (V)
AC Current (A)
Max. Gas Output(L/h)
Max. Working Pressure (Mpa)
Max. Water Consumption (L/h)
Dimensions - L*W*H (mm)
Effects of carbon cleaning
1. Reduce oil consumption
2. Reduce engine noise
3. Save car repairing cost
4. Prolong engine life
5. Increase 20% of engine power
6. Decrease 70% of air pollution
Causes of carbon cleaning failure
Method of exclusion
The machine does not work when the start button is pressed
Missing phase, carbon removal control board failure or air switch damage or emergency stop button has been pressed
1）1) Check the power supply
2）2) Replace the faulty device
3）Detect emergency stop button
When the equipment is working, the gas production is too low to meet the requirements for use.
The electrolyte concentration is too low, the electrolytic cell is too dirty, and the electrolyte is not clean.
Cleaning the electrolytic cell, descaling, replacing the electrolyte
Over pressure alarm
Equipment line blockage
Check equipment piping
Normal air pressure, low air output
Equipment piping leaks
Check equipment piping to find leaks and recover
Work indicator does not light after booting
The power module or power cable is not connected properly.
Check the line, replace the power module, and replace the power cordRelated Products